Messages

1

General Discussion / Export and resizing issues

« on: May 21, 2007, 06:50:50 AM »

After drawing a figure in WinFig I have exported it to .eps format.

Upon using the exported figure with a resize option (through width, keepaspect ratio options), I have found that the quality of the figure reduces drastically. Is there some way of over coming this problem?

Thanks in advance.

2

Feature Requests / Cutting tool

« on: May 21, 2007, 06:47:09 AM »

I wish that there should have been a cutting tool.

My requirement is as follows:

I would like to draw figures similar to those shown in the following links:

http://www.polarinstruments.com/fr/support/cits/images/ap123_1.gif

http://www.ee.bilkent.edu.tr/~microwave/programs/magnetic/hybrid/stripline1.gif

I tried by using a central rectangle with complete gray filling, following by POLYGON drawing tool to draw the edges so as to represent that the material extends to "infinity" horizontally.

Since I am unable to draw such a think, I felt that it there was a cutting tool, I could have moved along the vertical edges of the rectangle to make it appear as shown in the figure.

If there is any other way to work around the problem, please suggest.